According to Murphy's Law of Toilets, any time a bathroom can clog, it will clog. Normally, when a bathroom clogs you will just grab the closest flange plunger and get to work. But what happens when you can't do that? Maybe you just moved to a new location. Perhaps you're at your plunger-less buddy's house. Or, who knows, perhaps your dog just ate your old plunger! ...or something.
It does not matter why you do not have a plunger. What's what you are going to do next. Obviously, you're going to want to unclog the toilet even without your plunger. Luckily, this is not as hard (or gross) because you may guess! In fact, there are several surprisingly simple ways to clear up even tough clogs with no plunger. Here are the ones you need to try in Arvada:
First, catch a huge bucket of hot water. Important note: you need hot, however NOT water. Boiling water can decode the porcelain of the toilet bowl. Rather, simply fill a bucket with the hottest water that your tap can provide. Pour that water to the toilet bowl until it's nearly full and let it sit.
The warmth should help break down any solid waste for the bathroom to flush it down. If this doesn't work, don't panic--just move on to the upcoming methods. The"hot water hint" is just the place to get started.
Squeeze a lot of dish soap to the bowl. Allow it to sit for about fifteen minutes. The soap will help break down any solids. It'll also lubricate the bowl and also plumbing themselves, which makes it simpler for the clog to slide into the drain. Once you use the dish soap, try out the"hot water trick" again. Pour a pot of hot (not boiling!) Water into the bowl. Let it sit again, this time for about thirty minutes.
After you give the water and soap time to purge, attempt flushing . If that still has not solved the problem, try repeating this procedure again. You may also try letting the dish soap sitting more --even all evening!
If you happen to have Epsom salt lying around, you're in luck. Pouring Epsom salt into water triggers a chemical reaction that makes the water start to fizz and bubble. All that fizzing and bubbling can seriously help dissolve clogs.
Pour a hefty level of Epsom salt into the bowl. Allow it to sit for fifteen minutes, then try to flush. You need to see positive results after the initial flush. You might also combine this procedure with the dish soap and"hot water tip" for good measure.
Here is the most direct way to clear a clog. If you have attempted heat and chemical reactions without achievement, it's time to reach right in. Unfold a wire hanger, then stick it in the toilet bowl, and wiggle it around in the opening.
This could be sort of gross depending on just what the clog involves, thus we recommend wearing gloves. Be careful not to inadvertently damage the toilet bowl while you're working. Wire hangers can scratch ceramic if you're too rough or non-discriminate.
When you've unclogged your bathroom successfully, you will find a couple things you ought to do. First: go out and purchase a flange plunger. All these plungerless techniques will do in a pinch, but they're no substitute for the real article. Next, figure out why your toilet clogged in the first location. Can this happen a lot? If it does, it might be because there's a more significant issue with your house plumbing.
If that is the case, you should get in touch with the pros at Jet Plumbers Arvada Co. We are going to take a peek at your home's plumbing and figure out why you are dealing with those clogs. We will be able to help make certain that you don't need that fresh plunger for some time.
